Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 152)

Intelligent Peripheral Management Controller
ATCA-9405 Installation and Use (6806800M71G) 152
Table 8-17 on page 152 , provides the feature set supported with ATCA-9405:
5 Feature Configuration.
00h = disabled (Feature Selector = E0)
01h = enabled (Feature Selector = E0)
02h = restore factory default (golden) (Feature Selector = E1)
C0h = reload selected FPGA image (Feature Selector = E1)
03h - FFh = reserved
6 Persistency / Duration
00h = volatile. Actual duration depends on implementation.
01h - FFh = reserved
Response
Data 1 Completion Code is Generic, plus the following command-specific
completion codes:
80h = feature selector not supported.
81h = feature configuration not supported
82h = configuration persistency / duration not supported
2 LSB of Artesyn IANA Enterprise Number. A value of CDh is used.
3 2nd byte of Artesyn IANA Enterprise Number. A value of 65h is used.
4 MSB of Artesyn IANA Enterprise Number. A value of 00h is used.
Table 8-17 Feature Selector Assignments
Feature Selector Description
E0h FAILSAFE Function
Enable/Disable
E1h Select FPGA flash
Table 8-16 Set Feature Configuration Command (continued)
Byte Data field