Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 96)

BIOS
ATCA-7365-CE Installation and Use (6806800L73J) 96
4.4.4 iSCSI Setup for Base and Fabric Ethernet
The board supports boot from iSCSI block devices connected to Base or Fabric Ethernet. To
enable the iSCSI boot, proceed as follows:
1. From the menu, select Boot.
2. Under the Option ROM Execution sub menu, select the iSCSI item of Fabric
Network Boot setup option.
3. Save and Exit the BIOS setup.
4. To enter iSCSI setup, press Ctrl-D when the following message is displayed:
"Intel(R) iSCSI Remote Boot version 2.7.53 Copyright (c) 2003-2010 Intel Corporation. All
rights reserved. Press ESC key to skip iSCSI boot initialization. Press to run setup".
Figure 4-4 Option ROM Execution