Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 108)

BIOS
ATCA-7365-CE Installation and Use (6806800L73J) 108
4.5.2.7 Advanced -> Super IO Configuration
4.5.2.7.1 Advanced -> Super IO Configuration -> Serial Port 0 Configuration
Device Reset timeout 10..40 seconds
Default 20 sec. USB mass storage device Start Unit command
timeout. 10, 20, 30, 40 seconds.
Controller Timeout 1..20 seconds
Default 20 sec. The time out value for Control, bulk & interrupt
transfer. 1, 5, 10 , 20 seconds.
USB Device Name Auto, Floppy, Forced FDD,
Hard Disk, CD-ROM Mass storage device emulation type.
'AUTO' enumerates devices according to their media
format. Devices less than 530MB are detected as
floppies. Optical drives are emulated as 'CD-ROM',
drives with no media will be emulated according to a
drive type.
Forced FDD option can be used to force HDD
formatted drive to boot as FDD (e.g. ZIP drive).
Table 4-13 Advanced -> USB Configuration (continued)
Item Values Description
Table 4-14 Super IO Configuration -> Serial Port 0 Configuration
Item Values Description
Serial Port Enabled (Default)
Disabled Enable or Disable Serial Port (COM 0)
Change Settings Auto,
IO=3F8h IRQ=4 (Default),
IO=3F8h IRQ=3,4,5,6,7,10,11,12,
IO=2F8h IRQ=3,4,5,6,7,10,11,12,
IO=3E8h IRQ=3,4,5,6,7,10,11,12,
IO=2E8h IRQ=3,4,5,6,7,10,11,12
Select IO port and Interrupt settings for COM 0