Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 243)

Supported IPMI Commands
ATCA-7365-CE Installation and Use (6806800L73J) 243
8.4 Pigeon Point Specific Commands
The IPMC supports additional IPMI commands that are specific to Pigeon Point. This section
provides detailed descriptions of those extensions:
Table 8-24 Pigeon Point Extension Commands
Command
NetFn
(Request/Response)
CMD
Get Status Table 8-26 on page 244 0x2E/0x2F 0x00
Get Serial Interface Properties Table 8-27 on page 247 0x2E/0x2F 0x01
Set Serial Interface Properties Table 8-28 on page 248 0x2E/0x2F 0x02
Get Debug Level Table 8-29 on page 249 0x2E/0x2F 0x03
Set Debug Level Table 8-30 on page 250 0x2E/0x2F 0x04
Get Hardware Address Table 8-31 on page 251 0x2E/0x2F 0x05
Set Hardware Address Table 8-32 on page 251 0x2E/0x2F 0x06
Get Handle Switch Table 8-33 on page 252 0x2E/0x2F 0x07
Set Handle Switch Table 8-34 on page 253 0x2E/0x2F 0x08
Get Payload Communication Time-Out Table 8-35 on page
253
0x2E/0x2F 0x09
Set Payload Communication Time-Out Table 8-36 on page
254
0x2E/0x2F 0x0A
Enable Payload Control Table 8-37 on page 255 0x2E/0x2F 0x0B
Disable Payload Control Table 8-38 on page 255 0x2E/0x2F 0x0C
Reset IPMC Table 8-39 on page 256 0x2E/0x2F 0x0D
Hang IPMC Table 8-40 on page 256 0x2E/0x2F 0x0E
Graceful Reset Table 8-41 on page 257 0x2E/0x2F 0x11
Get Payload Shutdown Time-Out Table 8-42 on page 258 0x2E/0x2F 0x15
Set Payload Shutdown Time-Out Table 8-43 on page 259 0x2E/0x2F 0x16
Get Module State Table 8-44 on page 259 0x2E/0x2F 0x27
Enable Module Site Table 8-45 on page 261 0x2E/0x2F 0x28
Disable Module Site Table 8-46 on page 261 0x2E/0x2F 0x29