Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 239)

Supported IPMI Commands
ATCA-7365-CE Installation and Use (6806800L73J) 239
8.2.1 Set/Get Power Level
The blade supports two power levels. In case of a shelf which only allows 200W per slot the P-
States of the blade will be restricted to match this requirement. The second power level has no
restrictions.
For more information, refer to Chapter 4, BIOS, on page 89 .
8.3 Artesyn Embedded Technologies Specific
Commands
The Artesyn Embedded Technologies IPMC supports several commands which are not defined
in the IPMI or PICMG 3.0 specification but are introduced by Artesyn Embedded Technologies:
serial output commands.
The firmware upgrade commands supported by the blade are implemented according to
the PICMG HPM.1 Revision 1.0 specification.
The boot block can be updated with PICMG HPM.1 specific commands.
 Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Artesyn Embedded Technologies specific
IPMI commands by using the IPMI command 'Get Device ID'. Sending Artesyn Embedded
Technologies specific commands to IPMI controllers which do not support these IPMI
commands will lead to no or undefined results.
 Proper handling of these commands is required to write a portable application.