Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 110)

BIOS
ATCA-7365-CE Installation and Use (6806800L73J) 110
4.5.2.9 Advanced -> UEFI Network Stack
4.5.2.10 Advanced -> Runtime Error Logging
See Runtime Error Logging on page 121
Parity None (Default), Even,
Odd, Mark, Space A parity bit can be sent with the data bits to detect
some transmission errors. Even: parity bit is 0 if the
num of 1's in the data bits is even. Odd: parity bit is 0 if
num of 1's in the data bits is odd. Mark: parity bit is
always 1. Space: Parity bit is always 0. Mark and Space
Parity do not allow for error detection.
Stop Bits 1 (Default), 2 Stop bits indicate the end of a serial data packet. The
standard setting is 1 stop bit. Communication with
slow devices may require more than 1 stop bit.
Recorder Mode Enabled,
Disabled (Default) On this mode enabled only text will be send. This is to
capture Terminal data.
Resolution 100x31 Enabled,
Disabled (Default) Enables or disables extended terminal resolution.
Legacy OS Redirection 80x24 (Default), 80x25 Specifies the Number of Rows and Columns
supported by legacy serial redirection.
Table 4-16 Serial Port Console Redirection -> Console Redirection Settings (continued)
Item Values Description
Table 4-17 Advanced -> UEFI Network Stack
Item Values Description
UEFI Network stack Enable,
Disable (Default) Enable/Disable the UEFI network stack. This is needed for UEFI
network boot (PXE and iSCSI).
Table 4-18 Advanced -> Runtime Error Logging
Item Values Description
Runtime Error Logging Enabled (Default)
Disabled Enable/Disable Runtime Error Logging Support. Events
are sent to SMBIOS error log and IPMI SEL.