Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 59)

Hardware Preparation and Installation
ATCA-7365-CE Installation and Use (6806800L73J) 59
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 60 .
The additional resource (either memory or SATA SSD) will be detected
automatically during the boot-up sequence.
Removal Procedure
To remove a PMEM/SATA module, proceed as follows:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 60 .
2. Remove the two screws holding the PMEM/SATA module .
3. Remove the PMEM/SATA module from the blade.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 60 .
2.5.3 USB 2.0 Flash Module
The blades provides a USB 2.0 flash module with a capacity of 4 GB or 16 GB. The corresponding
removal/installation procedures are described in this section.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.