Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 233)

Supported IPMI Commands
ATCA-7365-CE Installation and Use (6806800L73J) 233
4 .. n (n <= 19) Data that you want to write into the addressed block. This will be a
chunk of the boot parameter data. If less than 16 bytes are written,
then only the provided data is written, the remaining bytes in the
addressed storage area block are left unchanged.
Response Data
1 0x00: Write successful
0x80: Boot parameter storage not supported by the IPMC
0x81: Storage area is locked by another software entity
0x82: Illegal write-access
0xC9: Block selector is outside of the allowed range.
Table 8-14 System Boot Options Parameter #100 - GET Command Usage
Byte Description
Request Data
1 Bit 7: reserved. Set to "0".
Bits 6..0: must contain the value: "100", indicating this OEM system
boot option.
2 Set Selector
0: User area
1: Default area
3 Block Selector
Zero based index of the 16-byte block which you want to read from.
Index 0 refers to the first block of 16 bytes, which includes the first two
bytes which indicate the boot parameter data size.
Response Data
1 0x00: Read successful
0x80: Boot parameter storage not supported by the IPMC
0xC9: Block selector is outside of the allowed range.
2 Reserved. Set to "1".
3 Bit 7: If set to "1", the addressed storage area is locked.
Bits 6 ..0: value "100", indicating this OEM boot option command.
Table 8-13 System Boot Options Parameter #100 - SET Command Usage (continued)
Byte Description