Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 122)

BIOS
ATCA-7365-CE Installation and Use (6806800L73J) 122
For correctable memory error logging, there are two additional parameters to prevent the
flooding of the event logs. The parameters are:
 Error Threshold - Correctable memory errors are logged when the threshold is reached.
The first correctable memory error is always logged.
 Error Logging Limit - The number of logged correctable memory errors for a DIMM is
limited. If the last entry in the log is SMBIOS: 'Correctable memory log disabled' and IPMI:
Memory event 'Correctable ECC logging limit reached'. No further correctable errors are
logged for this DIMM.
4.12.2 Error Simulation
For test purposes, it is possible to inject errors.
Enable 'Inject Errors' in 'Event Logs' -> 'SMBIOS Event Log Settings' in BIOS setup.
The following errors are injected short before the OS is booted:
 No Console found
 IPMI Boot Parameter Checksum error
 CPU Self test failure
 Bad battery
Table 4-28 Logged Error Events
Error SMIBIOS IPMI
Correctable:
- Correctable ECC Memory Error Single-bit ECC memory error Sensor: Memory, Offset 00h
Correctable:
- Memory Error Limit Reached
- Correctable ECC logging limit reached Correctable memory log disabled Sensor: Memory, Offset 05h
Uncorrectable:
- Uncorrectable ECC Memory Error Multi-bit ECC memory error Sensor: Memory, Offset 01h
PCI PERR PCI Parity Error Sensor: Critical Interrupt,
Offset 04h PCI PERR
PCI SERR PCI System Error Sensor: Critical Interrupt,
Offset 05h PCI SERR