Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 113)

BIOS
ATCA-7365-CE Installation and Use (6806800L73J) 113
4.5.3.2 IPMI -> System Event Log
4.5.4 iSCSI
This menu is for configuration of iSCSI boot of UEFI compatible Operating Systems. iSCSI boot
is enabled when UEFI Network stack is set to Enabled (see BIOS setup Advanced -> UEFI
Network Stack link).
FRB2 Timeout Action Do Nothing,
Reset (Default),
Power Down
Power Cycle Configure how the system should respond if the Frb2
Timer expires.
Not available if Frb2 Timer is disabled.
O/S Watchdog Timer Enable,
Disable (Default) If enabled, starts a BIOS timer just before booting the OS.
The OS has to shut off the watchdog timer when
successfully booted.
O/S Wtd Timer Timeout 1,2,3,5, 7, 10, 15, 20
minutes
Default 5 minutes
Configure the time out of the O/S Boot Watchdog Timer.
Not available if O/S Boot is disabled.
O/S Wtd Timeout Action Do Nothing,
Reset (Default),
Power Down
Configure how the system should respond if the O/S Boot
Watchdog Timer expires. Not available if O/S Boot
Watchdog Timer is disabled.
Table 4-22 IPMI -> IPMI Watchdog Configuration (continued)
Item Values Description
Table 4-23 IPMI -> System Event Log
Item Values Description
Log EFI Status Codes Disabled,
Both (Default),
Error code, Progress code Configure the logging of EFI Status Codes to IPMI
Firmware Progress/Error events and other Status/Error
IPMI events. See chapter 4.10.3 IPMI Error Logging