Artesyn ATCA-7365-CE Installation and Use (May 2014) - Manual (Page 114)

BIOS
ATCA-7365-CE Installation and Use (6806800L73J) 114
For every network device, there is a submenu for configuration of iSCSI boot.
Table 4-24 iSCSI
Item Values Description
iSCSI Initator Name The worldwide unique name of the initiator. Only IQN
(iSCSI Qualified Name) format is accepted.
Enalbe iSCSI Enable,
Disable (Default) Enable/Disable iSCSI for this Ethernet Port.
Enable DHCP Enable,
Disable (Default) Enable/Disable DHCP to retrive IP address, Subnet Mask,
Gateway…
Initator IP Address 0.0.0.0 IP Address of the Initator. Not available when DHCP is
enabled.
Initiator Subnet Mask 0.0.0.0 Subnet Mask for the Initiator Network. Not available
when DHCP is enabled.
GateWay Enter IP Address of Gateway. Not available when DHCP is
enabled.
Get target info via DHCP Enable,
Disable (Default) Get target info via DHCP.
Target Name Enter the Target Name. Not available when DHCP is
enabled.
Target IP Address 0.0.0.0 IP Address of the Target. Not available when DHCP is
enabled.
Target Port 0 Target Port. Not available when DHCP is enabled.
Boot LUN 0 Hexadecimal representation of the LUNumber. Examples
are: 4752-3A4F-6b7e-2F99, 6734-9-156f-127, 4186-9.
Not available when DHCP is enabled.
CHAP Type None (Default),
One Way,
Mutual Select the CHAP (Challenge-Handshake Authentication
Protocol) type.
Save Changes Press Enter to Save Changes
Back To Previous Page Press Enter to Return to the previous Page (same as ESC)