Adept DeskTop 4.3 - Manual (Page 74)

Adept DeskTop 4.3 - Online Help 74
Operation Editor
The Operation Editor allows you to configure and define an operation that will be added to the
Operations Manager. All operations defined in the
Operations Manager can be run from the Operator
Control .
Figure 46 Operations Editor Window in V+
Operation Name
In the Operation Name field, enter a unique, common name that will identify the operation.
Program Name
In the Operation Name field, enter the name of a program, currently in memory (in the Program
Manager), that defines the operation.
If this program may not be in memory when an operator launches it from the Operator Control, you can
define a program in the Source parameters, as explained below.
Source
Use Source parameters to set the location of a program that can be run from the Operations Manager,
when the required program is NOT in memory (not in the Program Manager).
To set Source parameters in V+
1. Click the browse button (...) to find the required program.
2. In the Open file dialog, browse and select the required program.
3. Enable the check box Also load data from file if you want to load the data associated to the
source program when the operation is executed.
To set Source parameters in MicroV+
1. Click the browse button (...) to find the required program.
2. In the Open file dialog, Browse and select the required program.
3. Enable the check box Also load data from file if you want to load the data associated to the
source program when the operation is executed.
4. Enabling Auto Load NVRAM will allow Adept DeskTop to load NVRAM to find the required
program if is not in memory.
Name that will be displayed in
the Operator Control
Enables buttons that will appear in
the Operator Control