Altera Stratix V Avalon-ST User Manual
Page 73
Signal
Direction
Description
• 5’b10011: Loopback.Exit
• 5’b10100: Hot.Reset
• 5’b10101: L0s
• 5’b11001: L2.transmit.Wake
• 5’b11010: Speed.Recovery
• 5’b11011: Recovery.Equalization, Phase 0
• 5’b11100: Recovery.Equalization, Phase 1
• 5’b11101: Recovery.Equalization, Phase 2
• 5’b11110: Recovery.Equalization, Phase 3
• 5’b11111: Recovery.Equalization, Done
sim_pipe_pclk_in
Input
This clock is used for PIPE simulation only, and is derived from
the
refclk
. It is the PIPE interface clock used for PIPE mode
simulation.
sim_pipe_rate[1:0]
Input
Specifies the data rate. The 2-bit encodings have the following
meanings:
• 2’b00: Gen1 rate (2.5 Gbps)
• 2’b01: Gen2 rate (5.0 Gbps)
• 2’b1X: Gen3 rate (8.0 Gbps)
txcompl0
Output
Transmit compliance
disparity to negative in compliance mode (negative COM
character).
txdata0[31:0]
Output
Transmit data. This bus transmits data on lane
txdatak0[3:0]
Output
Transmit data control
for
txdata
rxdata
, and so on. A value of 0 indicates a data byte. A value of 1
indicates a control byte. For Gen1 and Gen2 only.
txdataskip0
Output
For Gen3 operation. Allows the MAC to instruct the TX interface
to ignore the TX data interface for one clock cycle. The following
encodings are defined:
• 1’b0: TX data is invalid
• 1’b1: TX data is valid
txdeemph0
Output
Transmit de-emphasis selection. The value for this signal is set
based on the indication received from the other end of the link
during the Training Sequences (TS). You do not need to change
this value.
4-38
PIPE Interface Signals
UG-01097_sriov
2014.12.15
Altera Corporation
Interfaces and Signal Descriptions