Altera Stratix V Avalon-ST - Manual (Page 47)

Signal Directi
on
Description
•
cpl_err[4]
: Unsupported Request (UR) error for posted TLP. The
Application Layer asserts this signal to treat a posted request as an
Unsupported Request. The Hard IP automatically sets the error status bits
in the Configuration Space register and sends error messages in
accordance with the PCI Express Base Specification. Many cases of
Unsupported Requests are detected and reported internally by the
Transaction Layer. For a list of these cases, refer to Transaction Layer
Errors.
•
cpl_err[5]
: Unsupported Request error for non-posted TLP. The
Application Layer asserts this signal to respond to a non-posted request
with an Request (UR) completion. In this case, the Application Layer
sends a completion packet with the Unsupported Request status back to
the requestor, and asserts this error signal. The Hard IP automatically sets
the error status bits in the Configuration Space Register and sends error
messages in accordance with the PCI Express Base Specification. Many
cases of Unsupported Requests are detected and reported internally by the
Transaction Layer. For a list of these cases, refer to Transaction Layer
Errors.
•
cpl_err[6]
: Log header. If header logging is required, this bit must be set
in the every cycle in which any of
cpl_err[2]
,
cpl_err[3]
,
cpl_err[4]
,
or
cpl_err[5]
is set.
cpl_err_
fn[7:0]
Input Specifies the function reporting the error on
cpl_err[6:0]
.
cpl_pending_
pf[1:0]
Input Completion pending. The Application Layer must assert this signal when a
master block associated with PF0 is waiting for a completion. For
example, when a Non-Posted Request is pending from PF0.
cpl_pending_
pf[0]
records pending completions for PF0.
cpl_pending_pf[1]
records
pending completions for PF1.
cpl_pending_
vf[-1:0]
Input Completion pending from VF. The Application Layer must keep bit
asserted when the master block associated with Virtual Function is
waiting for Completion. For example, when a Non-Posted transaction is
pending from VF . is the number of VFs.
log_hdr[127:0]
Input When any of the bits 2, 3, 4, 5 of
cpl_err
is asserted, the Application Layer
may provide the header of the TLP that caused the error condition. The order
of bytes is the same as the order of the header bytes for the Avalon-ST
streaming interfaces.
ko_cpl_spc_
data[11:0]
Output The Application Layer can use this signal to build circuitry to prevent RX
buffer overflow for completion data. Endpoints must advertise infinite space
for completion data; however, RX buffer space is finite.
ko_cpl_spc_data
is
a static signal that reflects the total number of 16 byte completion data units
that can be stored in the completion RX buffer.
4-12 Completion Side Band Signals
UG-01097_sriov
2014.12.15
Altera Corporation Interfaces and Signal Descriptions
Send Feedback