Completion side band signals – Altera Stratix V Avalon-ST User Manual
Page 45
Signal
Direction
Description
mem_space_en_pf[
1:0]
Output
The PF0 and PF1 PCI Command Registers drive the Memory
Space Enable bit.
bus_master_en_pf[
1:0]
Output
ThePF0 and PF1 PCI Command Registers drive the Bus Master
Enable bit .
mem_space_en_vf[
1:0]
Output
The PF0 and PF1 Control Registers drive the SR-IOV Memory
Space Enable bit.
bus_master_en_vf[
1:0]
Output
The VF
Register drives bit
VFs.
Pf0_num_vfs[7:0]
Output
This output drives the value of the
NumVFs
register in the PF0 SR-
IOV Capability Structure.
Pf1_num_vfs[7:0]
Output
This output drives the value of the
NumVFs
register in the PF1 SR-
IOV Capability Structure .
max_payload_size[2:0]
Output
When only PF0 is present, the max payload size field of the PF0
PCI Express Device Control Register drives this output. When
two PFs are present, the minimum value of the max payload size
field of the PCI Express Device Control Registers drives this
output.
rd_req_size[2:0]
Output
When only PF 0 is present, the max read request size field of PF0
PCI Express Device Control Register drives this output. When
two PFs are present, the minimum value of the max read request
size fields of the PCI Express Device Control Registers drives this
output.
Completion Side Band Signals
The following table describes the signals that comprise the completion side band signals for the Avalon-
ST interface. The Stratix V Hard IP for PCI Express provides a completion error interface that the
Application Layer can use to report errors, such as programming model errors. When the Application
Layer detects an error, it can assert the appropriate
cpl_err
bit to indicate what kind of error to log. If
separate requests result in two errors, both are logged. The Hard IP sets the appropriate status bits for the
errors in the Configuration Space, and automatically sends error messages in accordance with the PCI
Express Base Specification. Note that the Application Layer is responsible for sending the completion with
the appropriate completion status value for non-posted requests. Refer to
on page 8-1
for information on errors that are automatically detected and handled by the Hard IP.
For a description of the completion rules, the completion header format, and completion status field
values, refer to Section 2.2.9 of the PCI Express Base Specification.
4-10
Completion Side Band Signals
UG-01097_sriov
2014.12.15
Altera Corporation
Interfaces and Signal Descriptions