Altera 100G Interlaken MegaCore Function - Manual (Page 9)

Device Speed Grade Support
Table 1-6: Minimum Recommended Device Family Speed Grades
For each device family the 100G Interlaken IP core supports, Altera recommends that you configure the
100G Interlaken IP core only in the device speed grades listed in the table, and any faster (lower numbered) device
speed grades that are available. Altera does not support configuration of this IP core in slower speed grades.
Device Family
IP Core Variation
12 Lanes 24 Lanes
10.3125 Gbps 12.5 Gbps 6.25 Gbps
Arria 10 I2, E2 I2, E2 I2, E2
Arria V GZ I3, C3 — I3, C3
Stratix V GX I3, C3 I2, C2 I3, C3
Stratix V GT I3, C3 I2, C2 I3, C3
Stratix V GS I3, C3 I2, C2 I3, C3
Release Information
Table 1-7: 100G Interlaken MegaCore Function Release Information
Item Value
Version 15.0
Release Date May 2015
Ordering Code IP–ILKN/100G
Vendor ID 6AF7
Product ID 00D6
Altera verifies that the current version of the Quartus II software compiles the previous version of each
MegaCore function, if this MegaCore function was included in the previous release. Any exceptions to
this verification are reported in the Altera IP Core Release Notes. Altera does not verify compilation with
MegaCore function versions older than the previous release.
A 100G Interlaken IP core with optimized feature set or low resource utilization is available by request.
UG-01128
2015.05.04
Device Speed Grade Support 1-5
About This MegaCore Function Altera Corporation
Send Feedback