Altera 100G Interlaken MegaCore Function User Manual
Page 74
Table 5-8: 100G Interlaken IP Core Arria 10 External PLL Interface Signals
Signal Name
Direction
Width (Bits)
Description
tx_serial_clk
Input
NUM_LANES
High-speed clock for Arria 10
transceiver channel, provided from
external TX PLL.
tx_pll_locked
Input
1
PLL-locked indication from external
TX PLL.
tx_pll_powerdown
Output
1
Output signal from the IP core
internal reset controller. The IP core
asserts this signal to tell the external
PLLs to power down.
Related Information
on page 2-12
Arria 10 Transceiver Reconfiguration Interface Signals
The 100G Interlaken IP core Arria 10 transceiver reconfiguration interface allows you to communicate
with Arria 10 hard PCS registers. This interface is available only in variations that target an Arria 10
device. You use this interface to reconfigure the transceiver and to take advantage of built-in transceiver
features that the 100G Interlaken IP Core supports for IP core testing. The interface allows you to address
a single register in a single transceiver channel at one time.
The Arria 10 transceiver reconfiguration interface is a typical 32-bit memory-mapped register port. It
complies with the Avalon Memory-Mapped (Avalon-MM) specification defined in the Avalon Interface
Specifications.
Table 5-9: 100G Interlaken IP Core Arria 10 Transceiver Reconfiguration Interface Signals
Signal Name
Direction
Width
(Bits)
Description
reconfig_clk
Input
1
Arria 10 transceiver reconfiguration interface clock.
reconfig_reset
Input
1
Assert this signal to reset the Arria 10 transceiver
reconfiguration interface.
reconfig_read
Input
1
Read access to the Arria 10 hard PCS registers.
reconfig_write
Input
1
Write access to the Arria 10 hard PCS registers.
5-16
Arria 10 Transceiver Reconfiguration Interface Signals
UG-01128
2015.05.04
Altera Corporation
100G Interlaken MegaCore Function Signals