Altera 100G Interlaken MegaCore Function - Manual (Page 35)

100G Interlaken IP Core Clock Signals
Table 4-1: 100G Interlaken IP Core Clocks
Clock Name Description
pll_ref_clk Reference clock for the RX transceiver PLL in IP
core variations that target an Arria 10 device.
Reference clock for RX and TX transceiver PLLs in
all other variations.
tx_serial_clk[NUM_LANES–1:0] Clocks for the individual transceiver channels in
100G Interlaken IP core variations that target an
Arria 10 device.
rx_usr_clk Clock for the receive application interface.
tx_usr_clk Clock for the transmit application interface.
mm_clk Management clock for 100G Interlaken IP core
register access.
reconfig_clk Management clock for Arria 10 hard PCS register
access, including access for Arria 10 transceiver
reconfiguration and testing features.
If you choose to instantiate the optional out-of-band flow control blocks, your 100G Interlaken MegaCore
function has additional clock domains.
Related Information
• Out-of-Band Flow Control Block Clocks on page 10-2
Comprehensive list of out-of-band flow control block clocks and information about their expected
frequencies.
• 100G Interlaken IP Core Clock Interface Signals on page 5-1
Lists the recommended and required frequencies of the 100G Interlaken IP core clocks.
IP Core Reset
The 100G Interlaken IP core variations have a single asynchronous reset, the
reset_n
signal. The
100G Interlaken IP core manages the initialization sequence internally. After you assert
reset_n
low, the
IP core automatically goes through the entire reset sequence.
Note: Altera recommends that you hold the
reset_n
signal low for at least the duration of two
mm_clk
cycles, to ensure the reset sequence proceeds correctly.
UG-01128
2015.05.04
100G Interlaken IP Core Clock Signals 4-5
Functional Description Altera Corporation
Send Feedback