EXFO PM-1600 High-Speed Power Meter - Manual (Page 16)

Safety Information
6 PM-1600
General Safety Information
General Safety Information
The following safety precautions must be observed during the operation
and servicing of the units. Failure to comply with these precautions or with
specific indications elsewhere in this manual violates safety standards of
intended use of the unit. EXFO assumes no liability for the user's failure to
comply with these requirements.
➤
This unit is intended for indoor use only.
➤
Unit covers cannot be removed during operation.
➤
The unit must be positioned in a way not to block the ventilation holes
located on each side of the unit.
➤
Installation of replacement parts or modification of the unit should be
carried out by authorized personnel only.
Laser Safety Information
W
ARNING
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation
exposure.
W
ARNING
Do not install or terminate fibers while a laser source is active.
Never look directly into a live fiber and ensure that your eyes are
protected at all times.
Safety Information
6 PM-1600
General Safety Information
General Safety Information
The following safety precautions must be observed during the operation
and servicing of the units. Failure to comply with these precautions or with
specific indications elsewhere in this manual violates safety standards of
intended use of the unit. EXFO assumes no liability for the user's failure to
comply with these requirements.
➤
This unit is intended for indoor use only.
➤
Unit covers cannot be removed during operation.
➤
The unit must be positioned in a way not to block the ventilation holes
located on each side of the unit.
➤
Installation of replacement parts or modification of the unit should be
carried out by authorized personnel only.
Laser Safety Information
W
ARNING
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation
exposure.
W
ARNING
Do not install or terminate fibers while a laser source is active.
Never look directly into a live fiber and ensure that your eyes are
protected at all times.