EXFO PM-1600 High-Speed Power Meter - Manual (Page 124)

Remote Control (SCPI) Commands
114 PM-1600
General Commands
*REM
Description This command is used to set the Remote programming state.
Syntax *REM
Parameters The parameter can be “1” to set the Remote
programming state to Remote or “0” to set the Remote
progamming state to Local.
Note This command can only be used with RS-232 communication.
*RST
Description This command empties the step response list. It is only seen
when it is part of another multiple command. In the example
below, by adding this command after *IDN?, you will not be
able to access the answer. The *RST, in this instance, erases the
identification string. In addition, this command performs the
following operations:
1. Returns to initial state before command was
sent and not necessarily to previous settings.
2. Forces the device to go into an Operation
Complete Command Idle State (OCIS).
3. Forces the device to go into an Operation
Complete Query Active State (OQAS).
4. Initialize sprevious responses unless there has
been a program message terminator
preceded by an *RST.
Syntax *RST
Example *IDN?;*RST
Remote Control (SCPI) Commands
114 PM-1600
General Commands
*REM
Description This command is used to set the Remote programming state.
Syntax *REM
Parameters The parameter can be “1” to set the Remote
programming state to Remote or “0” to set the Remote
progamming state to Local.
Note This command can only be used with RS-232 communication.
*RST
Description This command empties the step response list. It is only seen
when it is part of another multiple command. In the example
below, by adding this command after *IDN?, you will not be
able to access the answer. The *RST, in this instance, erases the
identification string. In addition, this command performs the
following operations:
1. Returns to initial state before command was
sent and not necessarily to previous settings.
2. Forces the device to go into an Operation
Complete Command Idle State (OCIS).
3. Forces the device to go into an Operation
Complete Query Active State (OQAS).
4. Initialize sprevious responses unless there has
been a program message terminator
preceded by an *RST.
Syntax *RST
Example *IDN?;*RST