beautypg.com

Initiate:autostop – EXFO PM-1600 High-Speed Power Meter User Manual

Page 130

background image

Remote Control (SCPI) Commands

120

PM-1600

Specific Commands

INITiate:AUTOstop

Description This command starts or stops an acquisition using the number

of points set with the TRAC:POIN command, and the sampling

rate set with the SENS:FREQ[:CONT] or the SENS:FREQ:NCON

commands. If this command is sent while an acquisition is in

progress, the “Acquisition already running” error message will

be raised.

Syntax

INIT:AUTO,

Parameters The value refers to

“0”- stop acquisition
“1”- start acquisition
The parameter refers to
“CONT”- use a low sampling rate
“NCON”- use a high sampling rate

Example

INIT:AUTO 1,CONT

See also

ABOR, INIT:AUTO?, INIT:CONT, INIT:CONT?, INIT[:IMM], and

TRAC:POIN

INITiate:AUTOstop?

Description This query returns the state of a programmed acquisition.

Syntax

INIT:AUTO?

Response

“0”- programmed acquisition is off
“1”- programmed acquisition is on

Example

INIT:AUTO?

See also

ABOR, INIT:AUTO, INIT:CONT, INIT:CONT?, INIT[:IMM], and

TRAC:POIN

Remote Control (SCPI) Commands

120

PM-1600

Specific Commands

INITiate:AUTOstop

Description This command starts or stops an acquisition using the number

of points set with the TRAC:POIN command, and the sampling

rate set with the SENS:FREQ[:CONT] or the SENS:FREQ:NCON

commands. If this command is sent while an acquisition is in

progress, the “Acquisition already running” error message will

be raised.

Syntax

INIT:AUTO,

Parameters The value refers to

“0”- stop acquisition
“1”- start acquisition
The parameter refers to
“CONT”- use a low sampling rate
“NCON”- use a high sampling rate

Example

INIT:AUTO 1,CONT

See also

ABOR, INIT:AUTO?, INIT:CONT, INIT:CONT?, INIT[:IMM], and

TRAC:POIN

INITiate:AUTOstop?

Description This query returns the state of a programmed acquisition.

Syntax

INIT:AUTO?

Response

“0”- programmed acquisition is off
“1”- programmed acquisition is on

Example

INIT:AUTO?

See also

ABOR, INIT:AUTO, INIT:CONT, INIT:CONT?, INIT[:IMM], and

TRAC:POIN