Trigger:sequence:level – EXFO PM-1600 High-Speed Power Meter User Manual

Page 152

Remote Control (SCPI) Commands

142

PM-1600

Specific Commands

TRIGger:SEQuence:LEVel

Description This command sets the power level of the trigger condition to

be met to start an acquisition in dBm or W, depending on the

currently selected unit. The trigger level must be set in absolute

power measurement mode and must be within the range of the

active channel. If this command is sent while an acquisition is

in progress, the “Acquisition already running” error message

will be raised.

Syntax

TRIG:SEQ:LEV

Parameters The is the trigger power level in the

“±99.9999 dBm” format or in the “+001.0000 E-12 W” to

“+999.9999 E+03 W” range.
The parameter represents the unit:
“DBM” dBm unit
“W” W unit

Example

TRIG:SEQ:LEV 16.804 DBM