EXFO PM-1600 High-Speed Power Meter - Manual (Page 135)

Remote Control (SCPI) Commands
High-Speed Power Meter 125
Specific Commands
SENSe:AVERage[:STATe]
Description This command activates or deactivates data averaging (for the
selected channel when using a PM-1620). If this command is
sent while an acquisition is in progress, the “Acquisition already
running” error message will be raised.
Syntax SENS:AVER[:STAT]
Parameters The parameter can be
“0”- disable averaging
“1”- enable averaging
Example SENS:AVER:STAT 1
SENSe:AVERage:STATe?
Description This query returns a value indicating whether data averaging is
enabled or disabled (for the selected channel when using a
PMD-1620).
Syntax SENS:AVER:STAT?
Response “0”- averaging is disabled
“1”- averaging is enabled
Example SENS:AVER:STAT?
Remote Control (SCPI) Commands
High-Speed Power Meter 125
Specific Commands
SENSe:AVERage[:STATe]
Description This command activates or deactivates data averaging (for the
selected channel when using a PM-1620). If this command is
sent while an acquisition is in progress, the “Acquisition already
running” error message will be raised.
Syntax SENS:AVER[:STAT]
Parameters The parameter can be
“0”- disable averaging
“1”- enable averaging
Example SENS:AVER:STAT 1
SENSe:AVERage:STATe?
Description This query returns a value indicating whether data averaging is
enabled or disabled (for the selected channel when using a
PMD-1620).
Syntax SENS:AVER:STAT?
Response “0”- averaging is disabled
“1”- averaging is enabled
Example SENS:AVER:STAT?