EXFO PM-1600 High-Speed Power Meter - Manual (Page 156)

Remote Control (SCPI) Commands
146 PM-1600
Specific Commands
TRIGger:SEQuence:STATe?
Description This query returns the status of the trigger condition.
Syntax TRIG:SEQ:STAT?
Response “0”-trigger inactive
“1”-trigger active
Example TRIG:SEQ:STAT?
See also TRIG:SEQ:LEV, TRIG:SEQ:LEV?, TRIG:SEQ:SLOP,
TRIG:SEQ:SLOP?, TRIG:SEQ:SOUR, TRIG:SEQ:SOUR?, and
TRIG:SEQ:STAT
UNIT:POWer
Description This command changes the measurement unit (for the selected
channel when using a PM-1620). If this command is sent while
an acquisition is in progress, the “Acquisition already running”
error message will be raised.
Syntax UNIT:POW
Parameters The parameter can be
“DB” or “0”-set measurement unit to dB
“DBM” or “1”-set measurement unit to dBm
“W” or “2”-set measurement unit to W (pW, nW, µW, mW...)
“W/W” or “3”-set measurement unit to W/W
Example UNIT:POW DBM
See also SENS:POW:UNIT, and SENS:POW:UNIT?
Remote Control (SCPI) Commands
146 PM-1600
Specific Commands
TRIGger:SEQuence:STATe?
Description This query returns the status of the trigger condition.
Syntax TRIG:SEQ:STAT?
Response “0”-trigger inactive
“1”-trigger active
Example TRIG:SEQ:STAT?
See also TRIG:SEQ:LEV, TRIG:SEQ:LEV?, TRIG:SEQ:SLOP,
TRIG:SEQ:SLOP?, TRIG:SEQ:SOUR, TRIG:SEQ:SOUR?, and
TRIG:SEQ:STAT
UNIT:POWer
Description This command changes the measurement unit (for the selected
channel when using a PM-1620). If this command is sent while
an acquisition is in progress, the “Acquisition already running”
error message will be raised.
Syntax UNIT:POW
Parameters The parameter can be
“DB” or “0”-set measurement unit to dB
“DBM” or “1”-set measurement unit to dBm
“W” or “2”-set measurement unit to W (pW, nW, µW, mW...)
“W/W” or “3”-set measurement unit to W/W
Example UNIT:POW DBM
See also SENS:POW:UNIT, and SENS:POW:UNIT?