Format:readings[:data – EXFO PM-1600 High-Speed Power Meter User Manual
Page 129
Remote Control (SCPI) Commands
High-Speed Power Meter
119
Specific Commands
FORMat:READings[:DATA]
Description This command changes the resolution of the displayed power
value when dB or dBm is selected (for the selected channel
when using a PM-1620). If this command is sent while an
acquisition is in progress, the “Acquisition already running”
error message will be raised.
Syntax
FORM:READ[:DATA]
Parameters The
“0”- no digits after the decimal point
“1”- one digit after the decimal point
“2”- two digits after the decimal point
“3”- three digits after the decimal point
“4”- four digits after the decimal point
“5”- auto-resolution, determined by the measured power level
Example
FORM:READ:DATA 3
Remote Control (SCPI) Commands
High-Speed Power Meter
119
Specific Commands
FORMat:READings[:DATA]
Description This command changes the resolution of the displayed power
value when dB or dBm is selected (for the selected channel
when using a PM-1620). If this command is sent while an
acquisition is in progress, the “Acquisition already running”
error message will be raised.
Syntax
FORM:READ[:DATA]
Parameters The
“0”- no digits after the decimal point
“1”- one digit after the decimal point
“2”- two digits after the decimal point
“3”- three digits after the decimal point
“4”- four digits after the decimal point
“5”- auto-resolution, determined by the measured power level
Example
FORM:READ:DATA 3