EXFO PM-1600 High-Speed Power Meter - Manual (Page 151)

Remote Control (SCPI) Commands
High-Speed Power Meter 141
Specific Commands
TRACe:POINts
Description This command sets the number of points that will be used in
the acquisition in the “9999” format. The maximum number of
points depends on the number of channels available on the
PM-1600 and on the selected sampling rate. If this command is
sent while an acquisition is in progress, the “Acquisition already
running” error message will be raised.
Syntax TRAC:POIN
Parameters The parameter is the number of points to be
acquired using a programmed acquisition.
Example TRAC:POIN 1200
See also TRAC:DATA? and TRAC:POIN?
TRACe:POINts?
Description This query returns the number of points that will be used in a
programmed acquisition.
Syntax TRAC:POIN?
Response The number of points in the “9999” format.
Example TRAC:POIN?
See also TRAC:DATA?
Remote Control (SCPI) Commands
High-Speed Power Meter 141
Specific Commands
TRACe:POINts
Description This command sets the number of points that will be used in
the acquisition in the “9999” format. The maximum number of
points depends on the number of channels available on the
PM-1600 and on the selected sampling rate. If this command is
sent while an acquisition is in progress, the “Acquisition already
running” error message will be raised.
Syntax TRAC:POIN
Parameters The parameter is the number of points to be
acquired using a programmed acquisition.
Example TRAC:POIN 1200
See also TRAC:DATA? and TRAC:POIN?
TRACe:POINts?
Description This query returns the number of points that will be used in a
programmed acquisition.
Syntax TRAC:POIN?
Response The number of points in the “9999” format.
Example TRAC:POIN?
See also TRAC:DATA?