Dukane DPC II Plus 9001:2000 - Manual (Page 94)

84
Dukane Manual Part No. 403–566–01
DPC ™ II Plus and EZ Welder System – User’s Manual
Table 7—I below summarizes the various method
and mode menus and references their Figure num-
ber. Table 7–II on the next page lists the data en-
try screens and references their Figure number. It
also gives the minimum and maximum values for
each of the parameters. The only variation be-
tween models is for weld energy. The high–fre-
quency (50kHz and 70kHz) models have a lower
power output, and the scale factor change enables
0.1 Joule resolution at these lower power levels.
Remarks
7–36 Momentary or Maintained TRIGGER TYPE
7–38 Single or Dual Pressure WELD MODE
7–39 Time or Energy WELD METHOD P1
7–41 Time or Energy WELD METHOD P2
7–35 Manual or Auto INITIATE MODE
7–26, 7–48 Enable or Disable AFTERBURST
7–25, 7–47 Afterburst PROCESS CONTROL
7–23, 7–45 Hold Time PROCESS CONTROL
7–22 Weld Method PROCESS CONTROL
7–37, 7–51 Weld Mode PROCESS CONTROL
7–15 WELD METHOD Weld By Time, Energy or Ground Detect
7–13 Enable or Disable AUTO STOP
7–8 Weld By Time or Energy WELD METHOD
7–6 Probe - Timed or Untimed TRIGGER METHOD
7–34 Press TRIGGER METHOD
7–4, 7–29
7–33, 7–52
Root Menu PROCESS SETUP
6–3, 7–3
7–4, 7–53
Previous Weld Cycle Data WELD CYCLE DATA
6–2, 7–2 Installed Modules CONFIGURATION
6–1, 7–1 DPC II Plus Firmware Version and Date STARTUP
Description Figure No. Menu Name
Dual Pressure Mode Only
Dual Pressure Mode Only
Press Trigger Method Only
Press Trigger Method Only
Press Trigger Method Only
Press Trigger Method Only
Probe Trigger Method
Press Board or Power Output
Modules
Table 7— I Process Control Menu Listing