Dukane DPC II Plus 9001:2000 - Manual (Page 43)

33
Dukane Manual Part No. 403–566–01
Section 4 – Controls & Displays
3. Process Control Panel
Menu Function Keys
The menu keys are shown in Figure 4–7. Their
function is described going across each row start-
ing at the upper left.
Pressing the GEN. INFO key displays
the DPC model, the firmware version
and the installed modules. A readout
for a DPC II Plus equipped with both
a Press Control module and a Power
Signal Output Module is shown in
Figure 4–8A. The DPC EZ Series is
shown in Figure 4–8B. Press CAN-
CEL to return to the previous menu.
The up arrow key increments the data
value each time it is pushed. Hold-
ing the key in continuously incre-
ments the value. This key is also used
to move the cursor up one line on a
menu selection screen
Pressing the HOLD key immediately
brings you to the Hold Time data
entry menu. You can quickly check
and/or change the setting using the
four arrow keys. Pressing ENTER
completes the process and returns
you to your last menu screen.
Pressing the WELD P1 key displays
the parameter(s) for the first pressure
setting. The value(s) can be quickly
checked and/or altered without go-
ing back through the menu sequence.
Pressing ENTER completes the pro-
cess and returns you to your last
menu screen.
Pressing the left arrow key selects
the next digit to the left of a param-
eter setting. The key is used when
entering values and moves the flash-
ing bar under the selected digit. The
selection wraps around to the right
digit after the left most digit posi-
tion is reached.
+
–
HOLD WELD
P1
WELD
P2
GEN.
INFO
AMP.
ADJUST CANCEL ENTER
MODE
Amplitude
Adjust
Decrement Enter
Right
Arrow
Cancel
Weld
Pressure 2
(DPC II Plus only)
General
Information
Increment
Hold
Weld
Pressure 1
Left
Arrow
Mode
DPC II Plus v1.50
PRESS + ENERGY
MORE INFO:
www.dukcorp.com/us/
GEN.
INFO
WELD
P1
HOLD
EZ Series v1.50
PRESS SYSTEM
MORE INFO:
www.dukcorp.com/us/
Figure 4–7 Menu Keys
Figure 4–8A DPC II Plus GEN INFO Display
Figure 4–8B DPC EZ GEN INFO Display
NOTE
For three of the ‘hot’ keys (HOLD, WELD P1,
and WELD P2), data can only be entered or
modified after the programming setup is
completed.