Dukane DPC II Plus 9001:2000 - Manual (Page 14)

4
Dukane Manual Part No. 403–566–01
DPC ™ II Plus and EZ Welder System – User’s Manual
Section 1 – Introduction describes the manual organization
and the key features of the Dukane DPC TM ( Dy-
namic Process Controller ) II Plus Generator.
Section 2 – Safety discusses OSHA regulations and safety
considerations.
Section 3 – Unpacking and Installation explains the DPC II
Plus placement and setup. It also shows the cable
connections for quick–start operation.
Section 4 – Controls describes the function of the front
panel controls, menu keys and status display.
Section 5 – Connectors gives the function, pinout and sig-
nal description of the rear panel connectors
on the DPC II Plus. Operation of the optional
modules is described in detail. The internal
jumper blocks to control process automation
are also identified.
Section 6 – Process Setup describes the overall menu or-
ganization of the DPC–II Plus, the setup and
operate modes and gives a brief summary of the
three main menus.
Section 7 – Process Control Menu describes the Hand
Probe, Timed Auto, MPC and Press mode
menus and the Weld Methods. It also covers
the user interface configuration and param-
eter values.
Section 8 – Limit Definition Menu describes the Suspect
Limit and Bad Limit menus in detail.
Section 9 – Utilities Menu describes the Setup File Utilities,
Part Count and Status Output menus in detail.
Section 10 –Hand Probe and Stack Assembly describes the
assembly and mounting of both hand probes and
probe stack assemblies.
Section 11 –System Checkout describes basic system
tests to ensure that the DPC II Plus is func-
tioning properly.
Manual Organization