Dukane DPC II Plus 9001:2000 - Manual (Page 28)

18
Dukane Manual Part No. 403–566–01
DPC ™ II Plus and EZ Welder System – User’s Manual
Figure 3-2 shows the use of a bracket kit in
mounting a DPC to a 19-inch equipment rack.
(Contact Ultrasonic Sales at Dukane, and request
Part Number US-1155.) The DPC illustrated
has the standard, angled front panel of impact-
resistant ABS plastic.
Rack Mounting
22002
2
0
0
STATUS
FAULT
ON LINE
INPUT TEST
OVERTEMP OVERLOAD
OFF LINE
0 20 40 60 80 100 PERCENTAGE OF AVAILABLE POWER PERCENTAGE OF AVAILABLE POWER
SYSTEM POWER OUTPUT
ON LINE
WELD P1
WELD P1
AMP. ADJUST
GEN. OINFO.
CANCEL ENTER
WELD P1
MODE
+
–
TEST OFF LINE
Dynamic Process Controller Dynamic Process Controller
D DPC II Plus PC II Plus
Approximate
17.35 inches (44 cm)
Appro
ximate
22.25 in
(57 cm)
19 inches (48 cm)
Allow 5 inches (13 cm) of space behind the DPC for cables
CAUTION
Allow space for air venti-
lation around the DPC II
Plus chassis, air intake and
exhaust. The fan draws in
fresh air to cool the inter-
nal components, reduce
thermal gradients and
increase component life.
When viewed from the
front, the fresh air intake is
on the right and the hot air
exhaust is on the left side.
If excessive dust accumulates
in the slots, wipe or vacuum
them clean. Do not use com-
pressed air as this may force
the dust inside the chassis.
ƽ
Figure 3-2 Rack-mounted DPC Using Bracket Kit