Electronics problem, Possible cause(s), What to do – Sears 113.197611 User Manual
Page 82: Troubleshooting
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
Electronics Problem
No display when ÜN/OFF button
pushed
Display shows: ele
Display dim
Display dark
Possible Cause(s)
Battery incorrectly installed
Battery contacts dirty
Dead battery
Display failure
Normal at battery installation
Reference points not set
Poor battery contact
Display failure
Low battery voltage
Saw very cold
Saw very warm
Display blanks after a few minutes Normal
Display blanks when moving car
riage, then re-appears when mo
tion stops
Normal when position is changed
rapidly
Display shows: EEE.E or EE.EE
Arm or carriage moved abruptly
or too rapidly when display is off
Display resets but immediately
shows EEE.E or EE.EE when
carriage is moved
Display does not change when
arm or carriage is moved
Display does not read 0“ or
45° at bevel or miter indexes
Defective encoder or display in
dicator
Wrong function selected
Defective encoder or display in
dicator
"O" reference points not set at in
dexed points
Miter and bevel encoders not
aligned
What to Do
Install battery correctly
Clean battery contacts
Replace with 6V, size J battery
Have electronics checked by Scars
No action
Set "0" reference points
Clean battery contacts
Have electronics checked by Sears
Replace with 6V, size J battery
Allow saw to warm above 32°F
Allow saw to cool below 120°F
Push ON/OFF to see display
No action
Re-set ”0" reference point(s)
Have electronics checked by Sears
Select correct function
Have electronics checked by Sears
Set "0" reference points
Align encoders
82