Assemble table lock mechanism, Assembly – Sears 113.197611 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly
9. Push slide arm supports until "L” brack
ets are flush with saw frame, then attach:
use one
1
/
2
" long truss head screw per sup*
port
{insert screw through "L" bracket)',
on
end of each screw put
17
/
64
" in. diam x 9d6
out. diam flat washer, then lock washer,
then nut and wrench tighten.
10. From underneath table, tighten pan
head screws in each slide arm support.
1111*1
Assemble Table Lock Mechanism
1. Set out:
-two slide arms
-two spacers
-two
1/4"
diam x Ivts" long pan head screws
-two
V
4
"
diam x long pan head screws
-six 17/64" in. diam x »i6 out. diam flat
washers
-two
1
/
4
" diam lock washers
-two Id" diam hex nuts
-two
1
/
4
" diam square lock nuts.
T
2. Snap spacer into each slide arm.
3. Drop slide arm into each slide arm sup
port so "nose" faces front of table and
"arm" extends over lock handle channel.
Round
Nose
Front
Of Saw
32