Saw safety instructions, Workpiece safety instructions – Sears 113.197611 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
d I li
Saw Safety Instructions
1. Use guard, pawls and spreader accord
ing to instructions. Keep them in working
order.
2. Routinely check saw for broken or
damaged parts. Repair or replace
damaged parts before using saw. Check
new or repaired parts for alignment, bind
ing, and correct installation.
3. Unplug saw before doing maintenance,
making adjustments, correcting align
ment, or changing blades.
4. Do not force saw. Use saw, blades and
accessories only as intended.
5. Have yellow key out and saw switched
off before plugging in power cord.
Workpiece Safety Instructions
1. Cut only wood, woodlike or plastic
materials. Do not cut metal.
2. Cut only one workpiece at a time.
Stacking or placing workpieces edge to
edge can cause user to lose control of
workpiece.
6. Before turning on saw, clear table of all
objects except workpiece to be cut and
necessary fixtures, clamps, or feather-
boards.
7. If blade jams, turn saw off immediately,
remove yellow key, then free blade. Do
not try to free blade with saw on.
8. Turn saw off if it vibrates too much or
makes an odd sound. Correct any prob
lem before restarting saw.
9. Do not layout, assemble, or setup work
with saw on, or while blade is spirming.
10.
Keep saw table clean.
11. Store items away from saw. Do not
climb on saw or stand on saw table to
reach items because saw can tip over.