Sears 113.197611 - Manual (Page 20)

Assembly
2. Identify right side panel by locating let­
ter "R" stamped near center of rear edge.
Position right side panel upright, so "J"
slot is at bottom and facing you.
3. Put spacer inside front bottom edge of
side panel, so two holes face 'T' slot and
large hole rests on bottom edge.
4. Attach spacer to side panel: use two
screws
{insert screws through side panel)',
on end of each screw put washer, then
1 / 4 "
nut, and wrench tighten.
5. In similar way, attach spacer to left side
panel.
6. Screw yg" nut onto each leveling foot.
7. Insert leveling foot through bottom
hole at front and rear of each side panel.
On end of each leveling foot put another
nut and finger tighten until it meets
surface.
Attach Door Hinges
1. Set out:
-four hinges
-eight 1/4" diam x V2" long truss head
screws
-eight
1
/
4
" diam lock washers
-eight
1 / 4 "
diam hex nuts.
2. Attach two hinges to each side panel:
use two screws per hinge
(insert screws
through hinge)',
on end of each screw put
washer, then nut, and wrench tighten.
20