Mount basic saw assembly, Assembly – Sears 113.197611 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly
10. Pu.sh bevel lock to left (locking direc
tion) as far as it will go. Space between
casting and bevel lock should be about
O
1 5
":
to increase space,
unlock bevel lock then
tighten lock nut on motor support;
to decrease space,
unlock bevel lock then
loosen lock nut on motor support.
11. Lock bevel lock. With tabs on outside,
insert one end of yoke plug into opening
in blade carriage, just behind bevel lock.
Push until plug snaps into place.
Mount Basic Saw Assembly
1. Set out:
-basic saw assembly
-eight
V
4
"
diam x
V
2
"
truss head screws
-eight
1
/
4
" diam lock washers
-eight
1
/
4
"
diam hex nuts.
2. Lift saw assembly by front edge and
column and place on cabinet so holes line
up.
3. Attach saw to cabinet: use eight screws
(insert screws through saw frame)',
on end
of each screw put washer, then nut and
wrench tighten.
4. Check and wrench tighten
all
nuts in
cabinet.
5. Put saw in location where it will be
used.
Saw
I
Q1
i
Cabinet
28