Sears 113.197611 - Manual (Page 76)

Maintenance
Other areas to lubricate include:
• cam surfaces of the rip lock assembly
• between column tube and column
support
{Elevate radial arm to.
point, then wipe face of column tube with
light film of oil.)
• foot assemblies, where foot levers go
through foot rods
Adjustments for Wear
Swivel Lock
The swivel lock is a friction lock that
prevents play between the casting and
blade carriage. If the carriage can be
moved bv hand when the lock is locked.
1. Unlock swivel lock.
2. Remove screw and nut from swivel
lock knob.
3. Note:
Lever portion of swivel lock con­
tains wrench used, to make this adjustment.
Separate wrench from lever by turning
wrench a few degrees counter-clockwise
to release tab.
4. Position wrench across corners of
square nut and move wrench to line up
with lever.
5. Test adjustment: hold wrench in place,
move blade carriage to a non-indexed
position, and lock swivel lock. Try to
move blade carriage by hand. If you can,
further tighten square nut.
6
. Unlock swivel lock and move blade to
rip position. If carriage does not "snap"
securely into pre-set position, loosen
square nut one quarter turn.
7. Re-install wrench and knob.
76