Assembly, On end of each screw put rubber bushing – Sears 113.197611 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly
3. Snap one U-clip onto left side of center
channel, so hole lines up with hole in
channel. Snap remaining four U-clips
over holes in sides of saw frame.
U-ClipOn
Center Channel
U-Clips
4. Put
11
/
64
" in. diam x a-^s" out. diam washer
on each 134" long mounting screw.
5. Stand table on edge. Put mounting
screws, with washers attached, into each
of five mounting holes
(insert screw
through table top);
on end of each screw
put rubber bushing.
Rubber
Grommet
Mounting
Holes
Mounting
Holes
Front Table
On Front Edge
6. Place table, top side up, on saw so
mounting screws line up with holes in U-
clips. Note:
Table will extend about T
beyond trim caps.
7. Tighten mounting screws into U-clips
until heads just touch table. Note:
Make
sure rubber bushings are not squeezed.
8. Start cup point set screw through each
leveling hole and into tee nuts. Use Ps"
hex wrench to tighten screws until flush
with table.
Leveling Hole
Leveling
Holes
31