Sears 113.197611 - Manual (Page 41)

Alignment and Adjustment
2. Place square so long edge rests on
table and short edge rests against blade
surface, not on a tooth.
3. There should be no gap between blade
and square. Note;
Not ail blades are per­
fectly flat. Check different points along
blade surface by making quarter turns and
looking for gap each time. Consider overall
fit of blade.
If there is no gap, no adjust­
ment is needed.
J
/■
V
}
Wrong Wrong
4. If there is a gap, adjust motor;
i) unlock bevel lock
ii) loosen four socket head screws behind
blade carriage
iii) move motor until blade rests flush
against square
iv) lock bevel lock.
5. Re-check alignment and adjust as
needed.
6. Tighten four socket head .screws be­
hind blade carriage.
41