Complete adjustments, Alignment and adjustment – Sears 113.197611 User Manual
Page 47
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Alignment and Adjustment
1. Lock blade in in-rip position (blade
towards column, motor towards table
front).
2
. Ixtwer blade until it just clears table.
3. Unlock rip lock, move blade back until
it touches fence, and lock rip lock.
4. Loosen pawls/spreader wing nut and
lower pawls/spreader to fence. Spreader
should rest flat against fence, and one set
of pawls should rest on top of fence.
5. If adjustment is needed:
i) loosen both spreader nuts
ii) slide spreader against fence and rest
pawls on fence
hi) tighten spreader nuts.
6
. Raise pawls/spreader unit up to guard
and tighten wing nut.
Complete Adjustments
Go to Digital Display Section and follow
instructions to install battery, align en
coders, and set zero reference points.
Correct
Wrong
1
i
47