Sears 113.197611 - Manual (Page 25)

Assembly
2. Position rear support so short tabs are
at top. Attach four slide brackets to cen­
ter support (make sure solid surface of
support faces out): use four screws
{insert
screws through slide brackets)', on end of
each screw put washer, then nut, and
wrench tighten.
3. With solid surface on top, put upper
support between rear and center sup­
ports, so it sits inside tabs of rear support
and inside center support.
4. Attach two slide brackets at top: posi­
tion them so larger holes line up on rear
support; use two screws per bracket
{in­
sert screws through slide bracket)',
on end
of each screw put washer, then nut, and
wrench tighten.
5. Tilt center slide assembly and slide in­
side cabinet, under front and rear skirts,
so center support rests on lower support.
6. Attach center slide assembly to front
and rear skirts: use tw'o screws per skirt
{insert screws through upper support)',
on
end of each screw put washer, then nut,
and finger tighten.
7. Attach center and rear supports to
lower support: use four screws
{insert
screws through front and rear supports)',
on
end of each screw put washer, then nut,
and wrench tighten.
25