Sears 113.197611 - Manual (Page 21)

Assembly
Attach Side Panels to Bottom Shelf
1. Set out:
-eight 1/4" diam x long truss head
screws
-eight i/4"diam lock washers
-eight
1
/
4
'' diam hex nuts.
2. Put bottom shelf on floor so bottom
surface faces you and angled end of lower
support points up. Slide right side panel
into place so four holes in side panel line
up with four holes in bottom shelf.
3. Attach panel to shelf: use four screws
(insert screws through side panel);
on end
of each screw put washer, then nut, and
wrench tighten.
4. In similar way, attach left side panel.
Attach/lnstall Spacers
DiKa~ Model WITHOUT Casters:
1. Set out;
-two W' diam x vV' long truss
head screws
-two t/4"diam lock washers
-two
V 4 "
diam hex nuts.
2. Attach spacers to bottom shelf: use one
screw per spacer
(imert screw through
spacer);
on end of screw put washer, then
nut and wrench tighten.
Door Model WITH Casters and Drawer:
1. Set out;
-two spacers
-two
1
/
4
" diam x V long truss head
screws
-two i/
4
"diam lock washers
-two 1/4" diam hex nuts.
2. Push foot levers down and towards out­
side so they will release and unlock foot
assemblies.
Angled End Of
Lower Support
Side
21