Install battery, To replace battery, Digital display – Sears 113.197611 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Digital Display
Install Battery
1. Set out
-battery
-battery cover.
2. Position battery with angled corner on
top right and slide battery all the way into
opening behind digital display, pushing
slightly downward until it snaps into place.
3. lo)ok at display. It should look like this:
If it shows nothing, push in and slightly
upwards on battery' to remove it, then re
install.
If there still is no display, remove bat
tery, wipe off contacts, then re-install.
If there is still no display , try a new
6
V
alkaline battery or contact Sears.
4. When display shows correctly, snap bat
tery cover into place.
5. hollow steps to align encoders and set
zero reference points.
To Replace Battery
1. Use screwdriver to pry off battery'
cover.
2. Push in and slightly upwards on battery
to remove it. Install new
6
V alkaline bat
tery.
3. Follow steps to set zero reference
points.
VjJ
49