Cisco 3200 - Manual (Page 238)

12-30
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a First Row Table Top Section
Step 9 Slightly separate the shelf to be replaced from the other shelves.
Caution Make sure that all remaining shelves stay on the display structure and do not fall between the structure
supports.
Tip Slide the shelves to the left; there is space on the left that is created by the open table door.
Step 10 Remove the splines from the slot at both edges of the shelf to be replaced.
Step 11 Place the new shelf on the display assembly.
Step 12 Place the splines in the slots at the edges of the new shelf.
Step 13 Press the shelves together.
Step 14 Attach the new shelf to its adjoining shelf or shelves using the splines.
Step 15 From the underside of the display structure, insert the draw bolts or cam locks and tighten them; then,
attach the connecting plate between the new shelf and its adjoining shelf or shelves.
Step 16 Attach the screws that connect the display shelves to the display assembly.
Step 17 Reattach the speaker boards and speaker cables. See Chapter 8, “Assembling the Remaining
Cisco TelePresence Elements” for detailed instructions.
Step 18 Reattach the projector screen.
Tip The projector screen comes with printed instructions that should assist you with replacing it. If you
cannot find the instructions, reverse the order of removal to install it.
Step 19 Power on the system by completing the steps in the “Powering On the System” section on page 12-4 .
Replacing a First Row Table Top Section
Complete these steps to replace a first row table top section.
Required Information, Tools, and Equipment
To remove and replace a first row table top section, you need the following tools:
• Medium and large Phillips screwdriver
• 10 mm wrench
Tip A 10 mm open end ratcheting wrench is useful to loosen and tighten the draw bolts or cam locks.
Note Make sure to retain all screws, connectors, and other parts during the disassembly.