Cisco 3200 - Manual (Page 189)

10-7
Cisco TelePresence System 3200
OL-14521-01
Chapter 10 First-Time Setup
Setting Up CTS Components
This section describes the procedures you make to set up the camera and includes the following topics:
• “Starting the Software Setup” section on page 10-7
• “Adjusting the Zoom” section on page 10-9
• “Focusing the Camera” section on page 10-12
Starting the Software Setup
To start the software setup, complete the following steps.
Step 1 Assemble the Large Camera Target.
When you slide the Camera target into the frame, make sure the target is centered in the frame between
the vertical lines at the top and bottom of the target.