Step 1 – Cisco 3200 User Manual

Page 140

Text mode
Original mode

8-4

Cisco TelePresence System 3200

OL-14521-01

Chapter 8 Assembling the Remaining Cisco TelePresence Elements

Parts List

Step 1

Place the assembly over the center display, then attach the Camera Assembly to the Camera Assembly
bracket.

For clarity, the display has been removed from the illustration in

Figure 8-1

Note

There are two foam pads on inside of the camera assembly. Make sure that the foam pad on the top of
the camera assembly touches the top of the display, and the foam pad on the front of the assembly
touches the front of the display. To make adjustments, loosen the four screws on the top of the camera
assembly and move the assembly forward or back as required; then, retighten the four screws.

Figure 8-1

Camera Assembly

201164