Cisco 3200 User Manual
Page 185
10-3
Cisco TelePresence System 3200
OL-14521-01
Chapter 10 First-Time Setup
Loading CTS Administration Software
Figure 10-2
System IP Address
Tip
If the IP address that displays is 192.168.100.2, the CTS 3200 could not contact the DHCP server or your
system does not use DHCP. If your network does not use DHCP, navigate to Configuration > IP
Settings, change the DHCP Enabled setting to No, and specify a static IP address, subnet mask, gateway
and DNS server. You must reboot your codec after you configure a static IP address.
Note
Step 3
After successful bootup, the CTS Administration Software loads. When CTS Administration Software
loading is complete, the Cisco IP telephone displays a welcome message, which displays the IP address
from which you will be able to access the CTS Administration software. The welcome screen only
appears the first time the system is booted up after initial installation or after a factory reset.
Note
The telephone will not be registered at this time. It will show a directory number of 7000 but the
telephone will not function as a telephone at this time.
Step 4
Make a note of the IP address that appears on the display. You use this IP address to log in to the Cisco
TelePresence System administration console.
Step 5
If you have not already done so, configure the Cisco Unified Communications Manager GUI. For
detailed instructions to configure Cisco Unified Communications Manager for use with your CTS 3200,
refer to the
for your software release.
Step 6
From the Cisco IP telephone welcome page, press Next. The system reboots.
Note
The system might reboot several times during the initial startup process.