Attaching the camera hood assembly – Cisco 3200 User Manual
Page 197
10-15
Cisco TelePresence System 3200
OL-14521-01
Chapter 10 First-Time Setup
Setting Up CTS Components
Figure 10-11
Positioning the Small and Large Targets for the Second Row
d.
Make sure that the targets are still be aligned within the green and red boxes on the display. See
for more information.
Step 7
Remove the targets and place them in front of the left camera.
Step 8
Complete
through
for the left camera.
Step 9
Remove the targets and place them in front of the right camera.
Step 10
Complete
through
for the right camera.
Attaching the Camera Hood Assembly
After you complete the camera adjustment, attach the camera hood assembly. See
Note
Attach the top hood before attaching the bottom hood.
Caution
Do not overtighten the screws, or use a power screwdriver to tighten the screws. The recommended
torque for the screws is 0.8N.m (7 inch-pounds).
In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or
using a screw that is too long, can cause the plastic hoods to break.
207152
Large target
Small target
10 ft
10 ft