Step 13 – Cisco 3200 User Manual
Page 170
9-16
Cisco TelePresence System 3200
OL-14521-01
Chapter 9 Routing Power and Signal Cables
Power Requirements for the Cisco TelePresence 3200
Step 13
Attach and route the power-over-Ethernet and HD Video cables for the camera.
Figure 9-13
Cabling the Camera Assembly
Note
The camera cluster can experience radio frequency interference issues if the camera Ethernet and
HD Video cables are routed, bundled, or tied together. Cisco recommends that you route the Ethernet
and HD Video cables separately and use cable ties to tie them to opposite sides of the frame
displays the rear view of the Cisco TelePresence System 3200. Left and right are reversed.
Tip
Before you plug cables into a codec, label each cable.
RJ45 Power over Ethernet
HDMI connector
204165
10
5