Potter PFC-6075R - Manual (Page 56)

5-50
PFC-6075R • 5403594 • REV D • 9/14
Programming Overview
The LEARN function is available through the control panel, and is an efficient way to automatically configure all system devices.
LEARN detects all connected devices, assigns a name and selects the applicable device type (i.e., module, sensor or P-Link
device). The system configuration mirrors a basic fire protection system where all inputs and outputs are a one-to-one relationship.
The panel configuration software allows custom programming and configuration for all points via a network or remote
computer. At the click of a mouse, you may fine-tune device behavior characteristics or create mapping zones for a more
sophisticated fire protection system. By using the system software, you will realize the power and flexibility of the PFC-6075R
system. (Please refer to “Panel Software Overview” and “Mapping Zones” in this section for details on these procedures.)
The Programming Cycle
The following is a recommended approach to programming the system:
1. Install Software
2. Address and Install SLCs
3. Run LEARN
4. Connect Ethernet Cable
5. Upload Data to Computer
6. Program the System
7. Download Configuration File
Note: This approach may eliminate programming errors, however, these are only recommendations.
Software Installation
It's easy to install the PFC-6075R software and requires only a few minutes to complete. Once done, the program automatically
creates a shortcut icon on your desktop for easy access.
The system software is compatible with Windows XP, Windows Vista and Windows 7 Operating Systems, and incorporates
conventional shortcuts and features (i.e., right click to display short cut menus, drag and drop, etc.). The software’s flexibility
enables you to effectively program individual and/or groups of devices. Several examples in configuring a basic fire system are
provided later in this section under the “System Programming” heading.
Note: The latest version of Microsoft .NET Framework is required.
To install the software:
y y Access the Potter website at www.pottersignal.com, and go to the "Fire Alarm Systems" link, then click the "Fire Panel
Configuration Software" icon to select program to download.
y y The default installation directory is: C:\ProgramFiles\Potter\Potter Fire Panel Programmer.
y y You may change the location of the application files.