Getting started, Ac charger, Usb charging – Sharp AQUOS Crystal User Manual

Page 17

Getting Started

AQUOS CRYSTAL

Internal Battery Replacement

Internal Battery is a consumable item; may need to be
replaced if operating time shortens noticeably. Internal
Battery is not user replaceable; its replacement incurs fees
and requires handset submission to a SoftBank Shop or
other appropriate servicer. For details, contact a SoftBank
Shop or SoftBank Customer Support,

General Information

When Using Mobile Light

Handset does not charge while Mobile Light is shining.
Turning on Mobile Light while charging causes charging to
stop.
Turning on Mobile Light when using Camera while charging
also causes charging to stop.
If battery level is low, handset may close Camera.

AC Charger

AC Charger is an optional accessory. Be sure to use SHCEJ1 or
ZTDAC1 (Micro USB, 1.0 A) specified by SoftBank Mobile Corp.
The following explains how to charge handset using SHCEJ1.

・See User Guide for corresponding AC Charger.

Insert Micro USB plug of AC Charger into External Device Port

・Insert Micro USB plug in correct orientation; otherwise,

External Device Port may be damaged. Check contours and
orientation of Micro USB plug before inserting it.

Extend blades and plug AC Charger into AC outlet

Charging starts and Notification Lamp illuminates red.

Notification Lamp goes out when charge is full.

・Notification Lamp illuminates green when charge is almost

full.

After charging, remove Micro USB plug from External Device
Port, then unplug AC Charger and retract blades

USB Charging

Connect handset to a PC with Micro USB Cable (SHDDL1;
optional accessory).

・Turn on PC first.
・Handset may not charge or charge slowly depending on

connection/PC status.

Insert Micro USB plug of Micro USB Cable into External Device
Port